Municipal Relations

Inspections

Inspection of gas and oil fired appliance and equipment

Manitoba Hydro Scope:

A licensed gas fitter must install all natural gas equipment and appliances with rating up to 400,000 BTU. An ITS authorized gas inspector will then check the installation to ensure that it has been installed according to all federal and provincial gas code requirements. Please contact MB Hydro at 1-888-624-9376 to book an inspection.

ITS Inspection Scope:

A licensed gas fitter must install all natural gas equipment where the total input of all units to be connected exceeds 400,000 BTU per hour. ITS authorized gas inspector will then check the installation to ensure that it has been installed according to all federal and provincial gas code requirements.

The purpose of the site inspection is to verify that:

  • An appliance/equipment is constructed according to the submitted documentation;
  • An appliance/equipment is installed in accordance with the applicable code and the manufacturer’s instructions;
  • The fuel features of an appliance/equipment perform the required functions, are set in accordance with the applicable code/standard, are operating within their certified specifications, use certified or approved components and comply with approved standards/codes
  • Appliances, equipment and components comply with approved codes and/or standards

To request an ITS inspection, contact Scheduling at Email: ITSinspections@gov.mb.ca or phone 204-945-3373.

Related Documents available on the Bulletins, Guides & Forms page:

  • ITS GO Form 01 – Appliance Inspection Ready General Checklist
  • ITS GO Form 02 – Assurance of Professional Design and Commitment for Inspection
  • ITS GO Form 03 – Construction Heater General Checklist
  • ITS 21-015 – Initial Start Up Procedure for Input Exceeding 400000 BTU
  • ITS 21-030 – Gas and Oil Review and Appeal Process
  • Various other ITS Bulletins